ABB ACS 600 MultiDrive, User Manual

Page: 14 / 109

Chapter 1 – Introduction
1-2 ACA 635 IGBT Supply Sections User’s Manual
ISU-related
Information in Other
Manuals Items concerning the ACA 635 not described in this manual are listed
below with a reference to the manual where they are described. For EN
codes of the manuals refer to the inside of the front cover of this
manual.
Task Described in Instruction/Information
Mechanical and
Electrical Installation of
ISU ACS 600 MultiDrive
Hardware Manual
(EN
code: 63700118) or
ACx 6x7 Hardware
Manual
(EN code:
61329005)
Perform the installation according to the instructions. See the required
general data from the
ACS 600 MultiDrive Safety and Product
Information guide (or Appendix A in ACx 6x7 Hardware Manual , EN
code 61329005) and the ISU specific data from Appendix A –
Technical Data in this manual.
Preventive
Maintenance as above
Installation of Optional
Modules and
DriveWindow as above Install any optional modules and Drive Window according to the
instructions given in Chapter 3 – Electrical Installation.
Associating ISU with
DriveWindow DriveWindow Start-up
Guide
EN code
36458585
When associating Drive Window 1.3 and 1.4 with the ISU proceed as
follows:
User Interface The use of the Control
Panel is described in
detail in
ACS 600
Firmware Manual (for
System, Standard or
Crane Drive Application
Program).
The user interface of the IGBT Supply Unit is a CDP 312 Control
Panel or PC, which is equipped with a DDCC board and Drive
Window .
System Configuration Messages What to do
Error: Encountered target ‘ISU600-
xxxx-x’ is unknown. Do you wish to
associate it? Click OK.
Associate ‘ISU600-xxxx-x’ With Choose ACS600 MultiDrive
from the list.
Do you wish association ‘ISU600-
xxxx-x’ = ACS600 MultiDrive be
permanent? Click Yes.