ABB ACS 600 MultiDrive, User Manual

Page: 65 / 109

Chapter 8 – Parameters
8-8 ACA 635 IGBT Supply Sections
9.11 SUPPLY FAULT
WORD
0 CHARGING FLT DC link short-circuit during charging
1 OVERCURRENT Overcurrent
2 DI5 = 0 External fault indicated via DI5
3 ACS 600 TEMP Power plate overtemperature
4 E EARTH FLT Earth fault detected by an external monitoring device
5 FAN FLT Fan failure. Fault is activated 5 seconds after failure.
6 MAIN CNT FLT Main contactor failure
7 SHORT CIRC Short-circuit in the main circuit (indication from power plate).
8 Internal faults. If this bit is 1 write down the value of Parameter
9.03. Contact ABB.
9 NET VOLT FLT Supply voltage out of range during synchronisation
10 CH0 COM LOST Communication break on CH0
11 Not in use
12 EARTH FAULT Internally detected earth fault
13 SYNCHRO FLT Synchronisation to supply failed
14 DC UNDERVOLT Intermediate circuit DC undervoltage
15 DC OVERVOLT Intermediate circuit DC overvoltage
9.12 SUPPLY ALARM
WORD
0 CH0 TIMEOUT Communication break detected
1 PANEL LOST Local control lost
2 Not in use
3 AI<MIN FUNC Current below 4 mA (4 mA minimum selected)
4 ACS 600 TEMP ACS 600 internal temperature excessive
5 CURRENT LIM Current limit exceeded
6...9 Not in use
10 NET LOST Network voltage lost
11, 12 Not in use
13 EARTH FAULT Internally detected earth fault
E EARTH FLT Earth fault detected by an external monitoring device
14 DI5 = 0 External fault indicated via DI5
15 Not in use
Code Parameter Bit Name Description
9 FAULT WORDS