ABB ACQ580-34, Hardware Manual

Page: 212 / 244

Start-up
￭
Setting the parameters
1. Power up the drive.
2. If no warning is shown,
• make sure that the value of both parameters 15.01 Extension module type and 15.02
Detected extension module is CHDI-01.
If warning A7AB Extension I/O configuration failure is shown,
• make sure that the value of parameter 15.02 is CHDI-01.
• set parameter 15.01 value to CHDI-01.
You can now see the parameters of the extension module in parameter group 15 I/O
extension module .
3. Set the parameters of the extension module to applicable values.
Parameter setting example for relay output
This example shows how make relay output RO4 of the extension module indicate the
reverse direction of rotation of the motor with a one-second delay.
Setting Parameter
Reverse 15.07 RO4 source
1 s 15.08 RO4 ON delay
1 s 15.09 RO4 OFF delay
Fault and warning messages
Warning A7AB Extension I/O configuration failure .
Technical data
Into an option slot on the drive control unit Installation
IP20 / UL Type 1 Degree of protection
See the drive technical data. Ambient conditions
Cardboard Package
Reley outputs (50…52, 53…55)
1.5 mm
2
Maximum wire size
12 V / 10 mA Minimum contact rating
250 V AC / 30 V DC / 2 A Maximum contact rating
1500 VA Maximum breaking capa-
city
115/230 V inputs (70…78)
1.5 mm
2
Maximum wire size
115 to 230 V AC ±10% Input voltage
2 mA Maximum current leakage
in digital off state
Isolation areas
212 CHDI-01 115/230 V digital input extension module