Aastra Dialog 4422 IP Office, User Manual, Page: 85 / 151

85 MD Evolution – Dialog 4422 IP Office
Group Services
Â
Press the Loudspeaker key on your extension.
If your extension was active within your primary group, it will now
be on standby. On the other hand, if your extension was on
standby, it will now be active within your primary group.
In relation to your secondary groups, your extension’s active or
inactive status is changed for all of them at the same time.
In either case, a confirmation that the service was accepted is pro-
vided both visually and audibly; the “Accepted Service” message is
displayed on the screen, and the service acceptance tone is played.
í
Press your extension’s “C” key to end this service.
Your extension returns to idle status.
When your extension is on standby within your primary group, that
status is represented on your idle extension with an “S” displayed
on the second line of the screen.
Notes:
The prefix “68” is the one usually used to access the standby
status service within a primary group. It may, however, have
been modified by your system administrator. The prefix for
accessing the standby service within secondary groups
differs from one facility to another.
Rx IN/OUT You may also program these standby services for your
primary and secondary groups on your extension’s repertory
keys. In this case, activating or deactivating standby would
be carried out by simply pressing the corresponding repertory
key. The associated LED status reflects your standby status:
an LED that is lit indicates standby, and an LED that is
turned off indicates that your extension is active in relation
to the involved group(s).
You may place your extension on standby at any time, even
if you are the last active member of a group. Your status is
managed completely independently from the opening and
closing of traffic for a specific group, which is the sole
responsibility of the hunt group supervisor (see details to
follow).
15:49 05 jun 2008
S 405
Õ Ô