Aastra 9000i Series, Administrator'S Manual

Page: 608 / 1043

41-001343-01 Rev 02, Release 3.2.2 5-331
The following table identifies when a call terminated screen displays on the phone for different
scenarios.
Configuring Indication of Terminated Calls
You can enable or disable whether or not the phone displays an indication of a terminated call
using the parameter, “
far-end disconnect timer
.” This parameter also specifies the maximum time
interval that the busy tone is audible on the phone. You can configure the indication of terminated
calls using the configuration files only.
Use the following procedure to configure this feature.
IF THEN
1 line active and far-end disconnects, the line in focus:
•
displays disconnected screen.
• plays busy tone.
• displays "Call Terminated" message on the screen.
the line not in focus:
•
plays busy tone.
2 or more lines active, and far-end disconnects, the line in focus:
•
displays disconnected screen.
• plays busy tone.
• displays "Call Terminated" message on the screen for 5
seconds. When 5 second times out:
- the busy tone stops
- the disconnected screen disappears.
2 or more lines active, and a line NOT in focus is
disconnected by the far-end, • no busy tone plays
• no disconnected screen displays
• no “Call Terminated” message displays
An incoming call comes in on the line in focus that has a
disconnected screen displaying, • the line in focus with no calls on hold:
- displays a ringing screen
• the line in focus WITH calls on hold:
- flashes its’ Line LED
An incoming call comes in on another line (NOT in focus),
and the disconnected screen is displaying on the line in
focus, • the disconnected screen no longer displays on the line in
focus.
A phone application is NOT in focus, • busy tone plays
• no disconnected screen displays
• When the phone application in focus on screen stops:
- busy tone plays
- disconnected screen displays
Note:
This “indication of terminated calls” feature does not affect parked
calls on the phone or the conference call feature.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Disable User
Login to Aastra Web UI” on page A-191.