Aastra 9000i Series, Administrator'S Manual

Page: 146 / 1043

41-001343-01 Rev 02, Release 3.2.2 3-59
Autodial Settings
You can configure the following Autodial settings.
Parameter In
IP Phone UI
Parameter in
Aastra Web UI
Parameters in
Configuration Files
Description
N/A Autodial Number
(Global and
Per-Line)
sip autodial number
sip lineN autodial
number
Globally or on a per-line basis, specifies the SIP
phone number that the IP phone autodials when the
handset is lifted from the phone cradle. An empty
(blank) value disables autodial on the phone.
For more information, see Chapter 4, “Autodial
Settings” on page 4-101 .
N/A Autodial Timeout
(Global and
Per-Line)
sip autodial timeout
sip lineN autodial timeout
Globally or on a per-line basis, specifies the time, in
seconds, that the phone waits to dial a
preconfigured number after the handset is lifted
from the IP phone cradle.
If this parameter is set to 0 (hotline), the phone
immediately dials a preconfigured number when
you lift the handset. If this parameter is set to a
value greater than 0, the phone waits the specified
number of seconds before dialing the preconfigured
number (warmline) when you lift the handset.
Default is 0 (hotline).
For more information, see Chapter 4, “Autodial
Settings” on page 4-101 .
N/A Use Global Settings
(Per-line
configurations only)
N/A For each line, this parameter specifies to use the
global autodial settings of “Autodial Number” and
“Autodial Timeout”.
For more information, see Chapter 4, “Autodial
Settings” on page 4-101 .