Operation and Maintenance
203
Aastra 470 as of R1.2
syd-0337/1.2 – R1.2 – 11.2011
Malfunction
With 3-digit error ID Hardware or software error
during self-test
With 5-digit error ID: General error during oper-
ation.
The error ID can help Support to pinpoint the
possible cause of the error.
Error ID, date, time
Memory usage below the crit-
ical range
The free storage space available in the file sys-
tem has once again increased above 3 Mbytes
File type ID, Usage, Date, Time
Memory usage over the criti-
cal range
The free storage space available in the file sys-
tem has dropped below 3 Mbytes
File type ID, Usage, Date, Time
Monitor Event
Monitor Event
Monitor Type, Date, Time
New certificate: Update SIP
node
A TLS certificate has been generated. Non-
Aastra SIP nodes must now be updated.
Date, time
No DECT-DSP channels avail-
able
DECT channels on DSP-0x overloaded
Date, time
No DTMF receiver available
for integrated mobile phones
A permanent DTMF receiver (for detection suf-
fix dialling function codes) could not be
assigned to an integrated mobile phone with
enhanced functionality.
BCS Ref., date, time
No free IP system phone
licences
An Aastra 5360ip/5361ip/5370ip/5380ip was
unable to register because there are too few IP
system phone licences.
Date, time
No response from network
No answer to Call Setup on BRI-T/PRI interface
Port number of the exchange
line circuit, date, time
Node:
Connection lost
A node is not connected to the Master for a cer-
tain amount of time (configurable).
Node number, date, time
Node:
Connection reestablished
A node is reconnected with the Master for a cer-
tain amount of time (configurable) after an
interruption.
Node number, date, time
Not enough mobile phone
licences
The connection setup with an integrated
mobile phone has failed because the number
of configured mobile phones is greater than
the number of licences available. All the inte-
grated mobile phones remain blocked until a
sufficient number of licences are available.
Number of licences, number of
configured mobile phones,
date, time
NTP: Synchronisation failed
Time synchronization via the NTP server (NTP =
Network Time Protocol) has failed.
Date, time
NTP: Synchronisation rees-
tablished
Time synchronization via the NTP server (NTP =
Network Time Protocol) has been restored.
Date, time
Numbers missing
Card(s) not full logged on
• Insufficient memory reserved in the number-
ing plan to enable allocation of numbers to all
users: Type in missing numbers by hand
Date, time
Outgoing call rejected
Call rejected by the network
• On any line: error code 34
• On required line group:
error code 44
Port number of the exchange
line circuit, cause, date, time
Event/ error message
Trigger condition
Details