Zone
Zone
MODULAR SYSTEM MANAGER SD
VCC-X Operator Interface SD
16
System Manager SD Keys and Buttons
Operator Interfaces
In order to con
fi
gure and program the Orion System controllers,
you must have an Operator’s Interface or a personal computer with
the Prism 2 computer front-end software installed. Three different
Operator Interfaces are available for programming of the Orion
Controls System—the Modular Service Tool SD, the Modular Sys-
tem Manager SD, and/or the System Manager TS II. These devices
allow you to access the status and setpoints of the controllers on your
communications loop. This manual describes the Modular System
Manager SD. If using the System Manager TS II, please see the
System Manager TS II Technical Guide
. If using Prism 2, please see
the
Prism 2 Technical Guide
.
The Modular System Manager SD allows you to view any input or
output status and change any setpoint to
fi
ne-tune the operations of the
total system. All keypad operations are simple and straightforward,
utilizing non-cryptic plain English messages.
Display Screens & Data Entry Keys
See the chart below for a list of the keypad descriptions and functions.
Keypad
Description
Function
ESC
Use this key to exit from screens or from data
entry or to return to the Main Screen from
any screen in the system.
ENTER
Use this key to enter a new value.
Clear
If a data entry mistake is made, press this key
to clear the data entry
fi
eld and start over.
Minus
If a setpoint with a negative value is required,
press this key for the minus sign.
DEC
Press this key when entering data that re-
quires a decimal point.
Use these keys to change values in the Con-
fi
guration Screens as prompted.
Use these keys to step backward or forward
through the screens.
Mode Selection Buttons
The Modular System Manager is provided with “Mode Selection
Buttons.” These buttons give you instant access to the speci
fi
c mode
desired without having to scroll through several menu screens to
get there.
Button
Description
Function
STATUS
Pressing this button takes you directly to
the controller “Status” screens.
SETPOINTS
Pressing this button takes you directly to
the controller “Setpoints” screens and
“Con
fi
guration” menu.
SCHEDULES
Pressing this button takes you directly to
the controller “Schedules” screens.
OVERRIDES
Pressing this button takes you directly to
the controller “Overrides” screen. See the
“Override Button” section on
page 21
for a
description of this function.
See Notes 1 & 2 below.
ALARMS
Pressing this button takes you directly to
the controller “Alarms” screen. See the
“Alarms Button” section on
page 20
for a
description of this function.
See Notes 1 & 2 below.
NOTES:
(1) This button only functions when the system is con
fi
gured for
“Network Mode” or “Multiple MGRS Mode.” It will not function
in “Stand Alone Mode.”
(2) The “Search for Units” function must be performed on the System
Manager upon initial system setup before this function will be avail-
able. See the “Network Mode & Multiple Managers Loop Search”
on
page 20
of this manual for complete instructions on performing
a loop search.
Table 3: Keypad Descriptions
Table 4: Button Descriptions
