HARDWARE INSTALLATION - DJI M600
38
10.
When everything is in the right place and aligned, you can begin tightening down the clamps on the rail system,
making sure to do everything in the correct order so that the spacers, RDS2 and camera gimbal mount are all in the
correct positions. You may have to move things around or unclamp the camera gimbal mount temporarily in order to
reach the bolts on the front rail clamps. Once tightened, you can put everything back and proceed to tighten the rest.
11.
Plug the included short USB cable into the Pi. Plug the other end into the innermost USB port on the RDS2
main board.
12.
Locate the 3 threaded holes located on the front left (when looking at the front of the drone) of the landing gear
mechanism. Using the 3 included bolts, mount the lidar module to the 3 threaded holes.
Summary of Contents for RDS2
Page 1: ...RDS2 USER MANUAL ...
