12
UNPACKING AND HARDWARE INSTALLATION
6.
In order to power the RDS2, you will need to route power from the drone down to the bottom of the frame. This
can be wired into the drone’s main power source. Solder a female XT30 connector to the power cable and route it
out the bottom of the frame.
For this example, the power is routed through the frame and into the main power distribution. The RDS2 is
running off of the drone’s main 6s (24v) power source. The XT30-end is routed through the frame for easy access
to the RDS2 power cable.
MavLink-Compatible Main Controller
Plug the 6 pin
connector into the
TELEM1 or
TELEM 2 port on
the flight controller
S
+
-
RC IN
M1
M2
M3
M4
M5
M6
M7
M8
M9
10
11
12
13
M14
TELEM1
TELEM2
GPS&SAFETY
UART4
CAN2
CAN1
I2C2
I2C1
CUAV X7+ shown here for reference
Summary of Contents for RDS2
Page 1: ...RDS2 USER MANUAL ...
