8mm
HARDWARE INSTALLATION - DJI M600
36
7.
Install the RDS2 on to the rail system. The front right rail (when looking at the front of the drone/RDS2 will receive
one short spacer between the case and the inner camera mount clamp. Place the other longer spacer between the
rear rail clamp and the rear of the RDS2 case. Look at the diagram on page 10 for the correct order on both sides. Do
not slide the RDS2 all the way onto the mount, as you will have to plug in the API cable from the drone into the RDS2.
8.
Plug in the A3 Pro API port cable into the Pi Zero, located on the front of the RDS2.
9.
Slide the RDS2 into the correct position. Use the spacers and camera mount spacing to help line everything up
properly.
There will be an 8mm gap between the mounting clamp and gimbal mount clamps in the front once
everything is installed. The RDS2 should not be able to slide in either direction once ecverything is tightened.
From top to bottom, make sure to
plug in black, then white, then grey.
IF YOU DO NOT PLUG IN THE API
CABLE CORRECTLY, YOU COULD
DAMAGE THE PI.
Summary of Contents for RDS2
Page 1: ...RDS2 USER MANUAL ...
