www.a2asimulations.com
ACCU-SIM V35B BONANZA
:::
A2A
SIMULATIONS
99
FOR SIMULATION USE ONLY
between the overhead fresh air scoop and the individual
fresh air outlets. The valve is operated by turning a knob on
the overhead panel.
EXHAUST VENT
A fixed exhaust vent is located in the aft cabin.
PITOT AND STATIC SYSTEMS
PITOT SYSTEM
The pitot system provides a source of impact air for opera-
tion of the airspeed indicator. The pitot mast is located on
the leading edge of the left wing.
PITOT HEAT
The pitot mast is provided with an electric heating element
which is turned on and off with a switch on the instrument
panel. The switch should be ON when flying in visible mois-
ture. It is not advisable to operate the pitot heating element
on the ground except for testing or for short intervals of
time to remove ice or snow.
NORMAL STATIC AIR SYSTEM
The normal static system provides a source of static air to
the flight instruments through a flush static fitting on each
side of the airplane fuselage. Aft of the rear closure bulk-
head (rear seat panel) is a drain plug, located at the low
point of the normal static system. It is provided in order to
drain moisture accumulations from the system. The closure
bulkhead is held in place with Velcro and may be removed
by pulling forward. The drain plug should be removed and
the moisture drained from the clear plastic line every 100
hours and after exposure to visible moisture, either in the
air or on the ground.
EMERGENCY STATIC AIR SYSTEM
An emergency static air source may be installed to provide
air for instrument operation should the static ports become
blocked. Refer to the EMERGENCY PROCEDURES Section for
procedures describing how and when to use this system.
INSTRUMENT PRESSURE SYSTEM
Instrument pressure is supplied by an engine driven pres-
sure pump. Pressure is controlled by an adjustable pressure
regulator on the forward side of the firewall.
A gage located in the upper right corner of the instrument
panel indicates the system pressure in inches of mercury.
The pressure should be maintained within the green arc for
proper operation of the pressure operated instruments.
STALL WARNING
A stall warning horn on the forward side of the instrument
panel sounds a warning signal (the battery switch must
be ON for serials 0-10097, 0-10120 and after) as the air-
plane approaches a stall condition. The horn is triggered by
a sensing vane on the leading edge of the left wing and is
effective at all attitudes. The warning signal will become
steady as the airplane approaches a complete stall.
Summary of Contents for BONANZA ACCU-SIM V35B
