4Ddoors DX250 SA, Instructions For Fitting, Operating And Maintenance

Page: 3 / 14

ENGLISH 3
1 NOTES AND CONFORMITY
1.1 General safety instructions
CAUTION
To install gate correctly, read these instructions carefully.
If installed wrongly or in case of incorrect working
process, serious injury can be caused.
• Packaging materials (plastic, polystyrene, etc.) should
not be stored in reach of children. If necessary please
dispose properly.
• This product has been developed and produced for the
use mentioned in these instructions only. Different use
may be source to damage and risks.
• The producer refuses every liability for damages caused
by improper or not intended use of the drive.
•
Conformity to EN-Standards:
Mechanical elements: EN 12604 and EN 12605.
Installation: EN 132411.
Safety devices: EN 12978
For countries not being part of the European Union
the above mentioned norms as well as the national
legal directives must be respected.
• The producer rejects every responsibility for
consequences, caused by non-professional production
of closing mechanisms or by deformation caused during
operation.
• Before every interference switch off power supply and
prevent from being switched on again.
• Install an all-poles separating safety switch with a
contact distance of at least 3mm before the power
supply line. In addition install an error current safety
switch using a trigger threshold of 0,03 A.
• Check if the grounding system was installed properly.
All metallic parts must be grounded.
• Install all safety devices (e.g. light barrier, safety strips
etc.) which avoid a person getting injured by jamming,
cutting or being dragged along.
• We recommend at least one fl ashing device for every
gate situation. In addition a warning sign should be
installed in sight.
• The producer rejects every liability regarding safety and
functioning of the installation site, if components of a
different brand are used.
• For maintenance and repair only original parts may be
used.
• No changes must be made to the components of the
installation site without permission of the producer.
• Familiarize the operator of the installation with the
correct handling of the installation. Explain the
emergency unlocking in case of power failure and hand
over the mounting instructions/ manual.
• No children or adults should stay near the installation
when in operation.
• The radio controls and every other transmitter should
be out of the reach of children to avoid an accidental
activation of the gate.
• The passing through should only take place when gate
does not move.
• The operator should not perform repairs or direct
interferences himself, he is supposed to contact
quali
fi ed professional staff.
•
Service
: Check functioning of gate, but especially
functioning of safety devices (including push force of
drive) and unlocking device at least twice a year.
• All procedures, not explicitly mentioned in this manual,
are not valid.
1.2 Declaration of incorporation for an
incomplete machine
Partly completed machinery as de fi ned in the EC Directive
2006/42/EC is only intended to be incorporated into or
assembled with other machinery or other partly completed
machinery or equipment, thereby forming machinery to
which this Directive applies. This is why this product must
only be put into operation after it has been determined
that the entire machine/system in which it will be installed
corresponds with the guidelines of the EC Directive
mentioned above.
After installation, the installer of the gate system must
declare conformity to DIN EN 13241-1 in accordance
with the scope of application.