28
B. REVERSAL HEIGHT IGNORANCE SETTING
a. Press and hold the
SET
Button until “1” appears on the
display, next press the
UP
button until “b” appears on
the display to enter this function setting then release
the button.
b. Press the
SET
button again. The unit is now in reversal
height ignorance adjustment mode. And then you will
see a figure “1” with flash dot appears on the display.
c. Press
UP / Down
button once to set the reversal height
ignorance while closing (0~9).
d. Press the
UP
button to increase , or the
DOWN
button
to decrease.
Figure “1~9” means the door will still not rebound
even though there’s obstacles in its closing path within
1cm~9cm away from the close position. This function is
most suitable for the Northern Europe where will always
snow on the ground.
e. Press the
SET
button to confirm the set and it will back
to standby status automatically and display “ll”.
NOTE
: The reversal height is set on “1” as standard in factory.
PROGRAMMING INSTRUCTIONS
INCREASE HEIGHT
DECREASE HEIGHT
Summary of Contents for 4DS2 v1
Page 1: ...Installation instructions and user guide Sectional and Tilting door operator 4DS2 v1...
Page 2: ......
Page 4: ......