International - ENG
February 2021
3M-Matic
™
7000r-I / 7000r3-I Pro
- Type 11700
Original Instructions
Page 40
Source
Document
for
all
related
Manuals/Translations
44-0009-2165-8 / ECO# 0078045
12.9 Trouble Shooting Guide
Cause
Narrow boxes
Worn drive belts
Upper taping head does not apply
enough pressure
Taping head applying spring
holder missing
Taping head applying spring set
too high
Worn or missing friction rings
Drive belt tension too low
Electrical disconnect
Circuit breaker not at correct
setting
Motor not turning
Machine's minimum height stop
does not match tape head leg
length setting
Worn belt
Dry compression rollers
Dry column bearings
Defective column bearings
Tape drum not centered
Centering guides not centered
Box flaps not of equal length
Problem
Drive belts do not
convey boxes
Drive belts
do not turn
Upper and lower
applying mechanisms
interfere with each other
Drive belts break
Squeaking noise as
boxes pass
through machine
Tape not centered on
box seam
Correction
Check machine specifications.
Boxes are narrower than
recommended, causing slippage
and premature belt wear.
Replace drive belts
Adjust the upper drive assembly
force adjust regulator to increase
the force against the top of
the box. Turn air regulator
counterclockwise
Replace spring holder
Reduce spring pressure
Replace friction rings
Adjust belt tension
Check power and electrical plug
Set to correct current value
Evaluate problem and correct
Check manual to make sure
taping heads match machine
setting
Replace belt
Lubricate compression rollers
Lubricate column bearings
Replace column bearings
Reposition tape drum
Adjust centering guides
Check box specifications
(
continued
)
12. Operation
(continued)