International - ENG
February 2021
3M-Matic
™
7000r-I / 7000r3-I Pro
- Type 11700
Original Instructions
Page 16
Source
Document
for
all
related
Manuals/Translations
44-0009-2165-8 / ECO# 0078045
Minimum/Maximum Box Height Combinations
(To relocate upper frame or outer columns, see “Special Set-Up Procedure”)
Case Height Range Illustration:
A. Standard Machine Position:
Outer Columns positioned against Stop with Upper Drive
Assembly set to Lowest Position on Inner Columns.
Tape Leg Length - 2.75” [70mm].
B. Raised Machine Position:
Maximum Box Height (i.e. Outer Columns and Upper Drive
Assembly in Highest Position - See Special Set-Up Procedure).
Tape Leg Length - 2.75” [70mm].
C. Lowered Machine Position:
Lowest Box Height, columns in lowest position heads in
offset position, Tape leg length 2”, Upper assembly in
lowest position, column bumpers removed.
Boxes narrower than 8” [200mm] may require more frequent belt replacement because of
limited contact area.
Special modifications may be available for carton sizes not listed on previous page.
Contact your 3M Representative for information.
Note:
The case sealer can accommodate most boxes within the size range listed above.
However, if the box length (in direction of seal) to box height ratio is .6 or less,
then several boxes should be test run to assure proper machine performance.
Any box ratio approaching this limitation should be test run to assure performance.
DETERMINE THE BOX LIMITATIONS BY COMPLETING THIS FORMULA:
BOX LENGTH IN DIRECTION OF SEAL = SHOULD BE GREATER THAN .6
BOX HEIGHT
Note:
Length of boxes in illustrations
are not to scale.
Minimum / Maximum
115mm 660mm
[4.5"]
[26"]
Operating
Range
Outer Column:
Fully Raised
Position
Box
Box
Minimum / Maximum
317mm 914mm
[12.5"] [36"]
A
B
Operating
Range
Box
Box
Standard Machine Position:
Outer Column against Stop /
Upper Assembly - Lowest
Position on Inner Column
4. Specifications
(continued)
Minimum / Maximum
57.15mm 647.7mm
[2.25"]
[25.5"]
Operating
Range
Box
Box
C
Lowered Machine Position:
Columns and Upper
Assembly in lowest postion /
Column bumpers removed.
