International - ENG
February 2021
3M-Matic
™
7000r-I / 7000r3-I Pro
- Type 11700
Original Instructions
Page 31
Source
Document
for
all
related
Manuals/Translations
44-0009-2165-8 / ECO# 0078045
2 - Remove tape drum bracket assembly, stud
spacer, fasteners from lower taping head.
3 - Install alternative wrap roller and bracket
on head in place of tape bracket.
Place lower head in machine.
4 - Install and secure tape drum bracket
assembly on the entry end of lower frame
(as shown in
Figure 7-23).
7.21 Preliminary Electric Inspection
Before connecting the machine to the mains
please carry out the following operations:
7.21.1
Make sure that the socket is provided
with
an earth protection circuit and that both the
mains voltage and the frequency match
the specifications on the name plate.
7.21.2
Check that connection of machine to
mains
meets safety regula-
tions in your country.
7.21.3
The machine is fitted with a main
switch and
circuit breaker. The user should check that
electrical settings of machine are compatible
with all the components of the mains system.
7.22 Machine Connection to the Mains
This machine may be recieved without an
electrical plug. Select a plug suitable for your
existing electrical service and compliant with
local electrial codes. Connect the Line, Neutral,
and Ground (Protective Earth) wires of the
machine to the appropriate terminals of the
plug following plug manufacturers instructions
One Way
Tension Roller
Tension
Wrap Roller
Knurled Roller
Wrap Roller
Applying Roller
Threading Needle
#1
#2
#3
#4
Figure 7-22
7.18 Box Sealing
1. Turn main air valve to “SUP” (On).
2. Turn pneumatic/electrical switch
(side of machine) to start machine.
3. Press Push Button Station “Start/
Stop” to start drive belts and Air
Pressure/Pneumatic operations.
4. Feed boxes to machine allowing
previous box to exit machine
BEFORE feeding next box.
5. Turn electrical/pneumatic switch
“Off” when machine is not in use.
6. Reload and thread tape as needed.
7. Be sure machine is cleaned and
lubricated according to recom-
mendations in “Maintenance”
section of this manual.
7.19 Completion of Taping Heads
See Manual 2 or 3 for Complete
Instructions:
1. Place the Upper Taping Head in
a convenient working position.
2. Use
Figure 7-22
and tape threading
label. Position the tape supply roll
so the adhesive side of tape is
facing the front of the taping head
as it is pulled from the supply roll.
3. Attach the threading needle to the
end of the roll. Guide the threading
needle around the wrap roller
(Position 1)
then back around the
one-way tension roller
(Position 2).
4. Continue pulling the threading
needle down and guide between
the two (2) rollers on the apply arm
(Position 3).
5. Pull threading needle down until
the tape travels between apply
plate and the ears of the apply arm
(Position 4)
until it extends past the
applying roller. When properly
threaded the adhesive side of the
tape should be facing the knurled
rollers at position 2 and position 3.
6. Cut away excess tape and repeat
steps for Lower Taping Head.
Important –
Do not cut against apply
roller - roller damage could occur.
7.20 Outboard Tape Roll Holder
To use the Outboard Tape Roll Holder:
1 - Remove lower taping head from
machine.
Figure 7-23
7. Installation
(continued)
