International - ENG
February 2021
3M-Matic
™
7000r-I / 7000r3-I Pro
- Type 11700
Original Instructions
Page 24
Source
Document
for
all
related
Manuals/Translations
44-0009-2165-8 / ECO# 0078045
7. Hold taping head Buffing Roller and
cut and remove cable tie that holds
applying/buffing arms retracted
(Applying/buffing rollers are held
retracted for shipment -
Figure 7-6)
.
Allow buffing/applying arms to
extend slowly.
Also cut and remove cable tie at
rear of lower taping head.
8. Check for free action of both upper
and lower taping heads. Push
buffing roller into head to check for
free, smooth action of taping heads.
9. Ensure that the tape drum bracket
assembly, located on the lower
taping head, is mounted straight
down
(Figure 7-8).
The tape drum
bracket assembly can be pivoted
to provide tape roll clearance in
certain cases.
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fingers away from
tape cutoff blades under orange blade
guards. The blades are extremely
sharp.
Warning
7. Installation
(continued)
Figure 7-7 7000r-I / 7000r3-I Pro Frame Set-Up
Buffing
Roller
Cable
Tie
C
Note:
Column Guads are
removed before Installing
the Bumper Supports.
Column Guards are
then installed.
B
Column Guards
A
