International - ENG
February 2021
3M-Matic
™
7000r-I / 7000r3-I Pro
- Type 11700
Original Instructions
Page 48
Source
Document
for
all
related
Manuals/Translations
44-0009-2165-8 / ECO# 0078045
A
B
Figure 13-8
Column Spacer (#1)
Upper
Assembly
Spacer(s)
Inner
Guard
replaces
existing
Guard
Column Spacer (#2)
13.12 Special Set-Up Procedure for
Outer Column Re-Positioning
(
continued
on next page)
Moving the outer columns will
increase/decrease the maximum
box height capacity of the
7000r-I/7000r3-I Pro
case sealer.
1. On both sides, place a solid
spacer block (as needed to
support column and to help
line up new holes) between
floor and bottom of outer
column
(Figure 13-8A)
.
2. On both front and rear, place
solid spacer blocks (14” [355mm])
and lower the upper taping head
assembly until the upper assembly
rests on blocks.
3. Remove eight (8) column screws
(Figure 13-8B)
.
4. Place second spacer block under
column
(Figure 13-8A)
.
5. Re-attach/tighten the eight (8)
screws and washers in each
column
(Figure 13-8B)
.
6. Remove existing guard and attach
inner guide plate using hardware
provided
(Figure 13-8B).
(
continued
)
Important!
When the column is
in the upper position, the
Inner Column Guard must
be
installed
(Figure 13-8B).
• To reduce the risk associated with
mechanical and electrical hazards:
- Turn peumatic and electrical supplies off
and disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
• To reduce the risk associated with
muscle strain:
− Use the appropriate rigging and
material handling equipment when
lifting or repositioning this equipment
• To reduce the risk associated with
impact hazards:
− Always use appropriate supporting
means when working under the
upper drive assembly.
Warning
Warning
Note:
Remove
Column
Screws
13. Maintenance and Repairs
(continued)
