Pannoramic SCAN 150 1.18 User’s Guide
5 Troubleshooting and Maintenance
5.3.6 Removing the magazine from the transporting system
Figure 84 – Removing a magazine
1. Remove the protective covers (see section
5.3.1 Removing the protective covers
).
Warning!
Crush hazard! Remember to stop the running digitization
process,
terminate the software session and turn off the power supply before
removing a jammed magazine.
Caution!
Check that the magazine is not tilted, so that it rests on both of the
horizontal guide rails.
2. If the magazine is in horizontal position, tilt plate
(7)
with the drive assembly for horizontal
magazine drive motion to the front far enough for the driving gear
(5)
to disengage from the
driving worm gear
(6)
.
April 3, 2014 - Rev. 1
3DHISTECH Ltd.
123(131)