4-16
C
H
A
P
T
E
R
4:
M
A
N
A
G
I
N
G
Y
O
U
R
H
U
B
U
S
I
N
G
Q
U
I
C
K
C
O
N
F
I
G
M
A
N
A
G
E
R
Figure 4-6
Alerts Panel
3
Configure the conditions for the Alert LED.
4
Click on
OK
when the Alert LED setup is complete.
If any Alert conditions are active, the conditions are
displayed in red. The other conditions are displayed
in green. If the active conditions are enabled, the
Alert LED will be lit.
In the Alerts
panel
:
Alert LED Test
Enabled /
Disabled
Allows you to test the Alert LED. If you select Enable
and click on
OK
, the Alert LED lights regardless of the
true alert condition of the hub.
When you have finished your test, remember to
disable to Alert LED Test. To do this, select Disable and
click on OK. The Alert LED now reflects the current
Alert condition of the hub.
UTP Port Partition
Enabled
/ Disabled
Allows you to specify whether the Alert LED lights if
a UTP port becomes partitioned, which happens if a
network loop occurs.
If this condition is resolved after causing the Alert
LED to light, the LED goes off (it stays lit if other
conditions also caused it to light).
16710.bk : MANAGING.FRM Page 16 Tuesday, October 7, 1997 11:38 AM
