160
C
HAPTER
6: ILMI C
ONFIGURATION
Add ATM Address to
Port
Adds an ATM address to the list of registered ATM addresses at a port.
Enter the port number and ATM address. Use this command, for
example, for IISP or E-IISP manual port configuration or for devices that
do not support IIMI.
Perform the command Save ATM Addresses to Flash (
“Save ATM
Addresses to Flash” on page 162
) before the next reboot to ensure that
your changes are saved.
Command Actions
Command Result
Example
Enter:
3 4 2 2 3.1
47.0.0.0.0.0.3c.0.0.b*.*.* .*.*.*.*.*.*.*.*
The following message is displayed.
Address already exists on port <6.1>, Use it again? (y/n) n
Enter the menu sequence:
(3) CON: Connections
(4) S&C: Setup and Config Conns
(2) STP: Atm address setup
(2) ADD: Add ATM address
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
ATM address
19 bytes—When fewer, end with '.*'
Direct access sequence:
3 4 2 2
[parameters]
System action taken:
The specified ATM address is added to specified port.
The change is not saved to flash memory.
System message display:
Address was set for port.
Summary of Contents for CoreBuilder 7000
