Managing Switch Modules
93
Enter
Y
to confirm,
N
to cancel reset. The box profile configuration
parameters are reset to their factory values.
The login access level will be switched to read only until the next reboot.
See Table 14 for a description of the parameters.
Managing Switch
Modules
The following command allows you to display switch module information
for the CoreBuilder 7000 family ATM switch.
Display Switch
Modules
Displays general information about each of the switch modules present –
1, 2, or both and detailed manufacturing information about the attached
module. If two switch modules are present in the same chassis, one is
used for redundancy. For more information about redundant switch
cards, see Chapter 10 in the Operations Guide.
Command Actions
Command Result
Example
This example is for a CoreBuilder 7000HD switch.
Enter:
1 4
Switch module information is displayed. See Table 16 for a description of
the information.
Enter the menu sequence:
(1) SYS: Platform config
(4) SWM: Switch modules
Direct access sequence:
1 4
System action taken:
Switch module information is displayed.
System message display:
See the example below and
Table 16
.
Summary of Contents for CoreBuilder 7000
