3Com CoreBuilder 7000, Management Manual

Page: 415 / 516

Setting Optimization Metrics 415
Command Actions
Command Result
Optimization Metrics Table Parameters
Table 54 describes the parameters that may be displayed in the
optimization metrics table.
Table 55 describes the values that may be assigned to the optimization
parameters. These parameters are used to determine the path in the
network for each Quality of Service.
Enter menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(5) OPT: Optimization Metrics
(1) GOP: Get Optimization
Metrics
Direct access sequence:
1 1 10 4 3 5 1
System action taken:
The PNNI optimization metrics table is displayed.
System message display:
Information is displayed as shown in the example.
Table 54
Classes of Service
Parameter Description
CBR Constant Bit Rate
RT-VBR Real Time Variable Bit Rate
NRT-VBR Non-Real Time Variable Bit Rate
ABR Available Bit Rate
UBR Unspecified Bit Rate
Table 55 Optimization Values
Value Description
0 - opt_admin_weight Optimized Administrative Weight (assigned to each
path in the network)
1 - opt_max_cr Optimized Maximum Cell Rate
2 - opt_av_cr Optimized Average Cell Rate
3 - opt_ctd Optimized Cell Transfer Delay