Set Store-and- Forward Mode
10-7
The system configuration mode is set according to following prompt. The
current mode is displayed after the colon. To accept it press “enter”; to
change it type over the new choice and press “enter”.
Select system mode (L<E>): L
Set Store-and-
Forward Mode
Set the desired store-and-forward mode. The mode is saved in flash. The
mode set applies to all frames arriving from all Ethernet ports and all
frames arriving from the ATM ports. This mode change takes effect only
after the next reset.
Example
Enter:
[1] [3] [6]
The store-and-forward mode is set according to following prompt. The
current mode is displayed after the colon. To accept it press “enter”; to
change it type over the new choice and press “enter”.
Select mode (S<&F>, C<utThru>): C
Table 10-7
Task Actions
Menu
Sequence
Enter
Result
[1] system [3]
update [6]
s&f
Enter
S<&f>
or
C<utthru>
Q
Store & forward - the entire
frame is received before being
forwarded to its destination.
Q
Cut-through - the cells of the
frame are forwarded to their
destination before the entire
frame is received
abtthgde.book Page 7 Tuesday, June 23, 1998 10:29 AM
