ZyXEL Communications MES-2110, Руководство пользователя

Страница: 120 / 184

Chapter 17 IP Source Guard
MES-2110 User’s Guide
120
17.1.1.1 Trusted vs. Untrusted Ports
Every port is either a trusted port or an untrusted port for DHCP snooping. This
setting is independent of the trusted/untrusted setting for ARP inspection. You can
also specify the maximum number for DHCP frames that each port (trusted or
untrusted) can receive each second.
Trusted ports are connected to DHCP servers or other switches. The Switch
discards DHCP frames from trusted ports only if the rate at which DHCP frames
arrive is too high. The Switch learns dynamic bindings from trusted ports.
Note: If DHCP is enabled and there are no trusted ports, DHCP requests will not
succeed.
Untrusted ports are connected to subscribers. The Switch discards DHCP frames
from untrusted ports in the following situations:
• The frame is a DHCP server frame (for example, OFFER, ACK, or NACK).
• The source MAC address and source IP address in the frame do not match any
of the current bindings.
• The frame is a RELEASE or DECLINE frame, and the source MAC address and
source port do not match any of the current bindings.
• The rate at which DHCP frames arrive is too high.
17.1.1.2 DHCP Snooping Static Binding Table
The Switch stores the binding table in volatile memory. If the Switch restarts, it
loads static bindings from permanent memory but loses the dynamic bindings, in
which case the devices in the network have to send DHCP requests again. As a
result, it is recommended you configure the DHCP snooping database.
17.1.1.3 Configuring DHCP Snooping
Follow these steps to configure DHCP snooping on the Switch.
1
Enable DHCP snooping on the Switch.
2
Configure trusted and untrusted ports, and specify the maximum number of DHCP
frames that each port can receive per second.
3
Configure static bindings.