ZyXEL Communications MES-2110, Руководство пользователя

Страница: 104 / 184

Chapter 15 Link Aggregation
MES-2110 User’s Guide
104
The following table describes the labels in this screen.
15.5 Link Aggregation Control Protocol
Click Configuration > Trunk Config > LACP Configuration to display the
screen shown next. See Section 15.2 on page 101 for more information on
dynamic link aggregation.
Figure 51 Configuration > Trunk Config > LACP Configuration
The following table describes the labels in this screen.
Table 42 Configuration > Trunk Config > Aggregator Setting
LABEL DESCRIPTION
Group This is the trunk group index number.
The Switch supports up to four trunk groups for 100Mbps ports and up to
two trunk groups for Gigabit ports. 100Mbps ports and Gigabit ports cannot
be in the same group.
Members Select the port(s) that belong to a trunk group.
For Groups 1 to 4, you can select up to four port members for each group.
For Group 5, you can select the two Gigabit ports as the members.
LACP Use this to enable or disable LACP port trunking.
Undo Click this to restore your last saved settings.
Apply Click this to save your changes.
Table 43 Configuration > Trunk Config > LACP Configuration
LABEL DESCRIPTION
Port State
Activity Select the port to enable Link Aggregation Control Protocol (LACP).
Hash-mode Use this to specify the outgoing traffic distribution type.
Select Lookup to distribute frames based on the destination MAC address.
Select Xor to distribute frames based on the last 3 bits of the source MAC
address and the trunk mask load balancing table.