ZyXEL Communications MES-2110, Руководство пользователя

Страница: 105 / 184

Chapter 15 Link Aggregation
MES-2110 User’s Guide
105
15.6 LACP Link Status
Click Configuration > Trunk Config > LACP Link Status in the navigation
panel to open the following screen.
Figure 52 Configuration > Trunk Config > LACP Link Status
The following table describes the labels in this screen.
System
Priority LACP system priority is a number between 1 and 65535. The switch with
the lowest system priority (and lowest port number if system priority is the
same) becomes the LACP “server”. The LACP “server” controls the
operation of LACP setup. Enter a number to set the priority of an active
port using Link Aggregation Control Protocol (LACP). The smaller the
number, the higher the priority level.
Undo Click this to restore your last saved settings.
Apply Click this to save your changes.
Table 43 Configuration > Trunk Config > LACP Configuration (continued)
LABEL DESCRIPTION
Table 44 Configuration > Trunk Config > LACP Link Status
LABEL DESCRIPTION
Actor This is the local Switch.
MAC This is the local Switch’s MAC address.
Priority This is the local Switch’s priority level.
Port ID This shows the port number belonging to the trunk group.
Key This is the local Switch’s key value.
Priority This is the port priority level.
Partner This is the peer Switch.
MAC This is the peer Switch’s MAC address.
Priority This is the peer Switch’s priority level.
Port ID This shows the port number belonging to the trunk group.
Key This is the peer Switch’s key value.
Priority This is the port priority level.