ZyXEL Communications ALC-1024L, Руководство пользователя

Страница: 35 / 105

Commands with MSC
Commands with MSC 2-5
Table 2-1 Standard Shell Commands
COMMANDS DESCRIPTION
smcast You can use the join/leave command to
add/remove multicast MAC addresses on
specific ports. This can also be applied to a
range of ports, all line card ports or all MSC
ports. You may specify up to ten MAC
addresses per port.
The static multicast filter can be applied to
pass routing protocols, such as RIP and
OSPF.
set <slot-
port|sub1|sub2|up1|up2
|all>
<xx:xx:xx:xx:xx:xx>
<join|leave>
Use this command to create or modify a
static multicast group.
delete <xx:xx:xx:xx:xx:xx> Remove a static multicast frame by deleting
the associated MAC address.
show Display all MAC addresses joined to static
multicast frames.
Command
<slot>
Sends commands to the line card in the
specified slot.
lineinfo <port> This command shows the statistics of the
specified DSL ports.
lineperf <port> This command shows the line quality of the
specified DSL port.
loopback <port> <local | f5> Performs loopback test. <mode> = "local" or
"f5"
list port <port> Displays line settings.
list ports Displays line settings on all ports.
stat ch <port> Displays channel status of a DSL line.
stat chs <port> Displays channel status of all DSL lines.
linedata <port> Displays the line data load per symbol
(tone).
linerate <port> Displays the line rate.
show port <port> Displays the line status (either up or down)
of a port.
show ports Displays the line status (either up or down)
of all ports.
2.4 Engineer Shell Commands with MSC
The engineer shell commands are backwards compatible with the command structure of earlier versions of the
management switch card’s firmware.