ZyXEL Communications ALC-1024L, Руководство пользователя

Страница: 45 / 105

Commands with MSC
ADSL Port Commands 3-7
lcman port profile set adsl <profile> <fast|interleave[=<up delay>,<down
delay>]> <up max rate> <down max rate>[<up target margin> <up min margin> <up
max margin> <up min rate> <down target margin> <down min margin> <down max
margin> <down min rate>]
where
<profile> = The descriptive name for the profile.
<fast|interleave[=
<up delay>,<down
delay>]>
= The latency mode.
<up max rate> = The maximum ADSL upstream transmission rate.
<down max rate> = The maximum ADSL downstream transmission rate.
<up target margin> = The target ADSL upstream signal/noise margin (0-31db).
<up min margin> = The minimum acceptable ADSL upstream signal/noise margin (0-31db).
<up max margin> = The maximum acceptable ADSL upstream signal/noise margin (0-31db).
<up min rate> The minimum ADSL upstream transmission rate.
<down target
margin>
= The target ADSL downstream signal/noise margin (0-31db).
<down min margin> = The minimum acceptable ADSL downstream signal/noise margin (0-
31db).
<down max margin> = The maximum acceptable ADSL downstream signal/noise margin (0-
31db).
<down min rate> =
The minimum ADSL downstream transmission rate.
The profile is a table that contains information on ADSL line configuration. Each entry in this table reflects a
parameter defined by a manager, which can be used to configure the ADSL line.
Note that the default value will be used for any of the above fields that are omitted.
The upstream rate must be less than or equal to the downstream rate.
Even though you can specify arbitrary numbers in the
profile set
command, the actual rate is always a
multiple of 32 Kbps. If you enter a rate that is not a multiple of 32 Kbps, the actual rate will be the next lower
multiple of 32Kbps. For instance, if you specify 60 Kbps for a port, the actual rate for that port will not exceed 32
Kbps, and if you specify 66 Kbps, the actual rate will not be over 64Kbps.
Two examples are shown next,
ras> lcman port profile set adsl debug fast 800 8000
ras> lcman port profile set adsl debug interleave=16,16 800 8000
This command creates new profiles (one for fast mode and one fore interleave mode) with the maximum upstream
transmission rate of 800 kbps and the maximum downstream transmission rate of 8000 kbps. None of the other
settings are set.