ZyXEL Communications ALC-1024L, Руководство пользователя

Страница: 47 / 105

Commands with MSC
ADSL Port Commands 3-9
<anxb|etsi|auto> =
The operational mode for ALC1024-63. Choose from
anxb
,
etsi
or
auto
.
The
port set
command assigns a specific profile to an individual port and sets the port’s mode (or standard).
The profile defines the maximum and minimum upstream/downstream rates, the target upstream/downstream signal
noise margins, and the maximum and minimum upstream/downstream acceptable noise margins of all the ADSL
ports to which you assign the profile.
The mode parameter specifies the standard that this port is allowed. When set to auto, the line card follows
whatever mode is set on the other end of the line.
When the mode is set to auto and the negotiated mode is G.lite, if the configured rates exceed
those allowed by G.lite, the actual rates are governed by G.lite, regardless of the configured
numbers.
An example is shown next.
ras> lcman port set 3-1 debug anxb
This command sets ADSL port 1 on the line card in slot 3 to have the debug profile in
anxb
mode.
3.2.11 PVC Set Command
Syntax:
lcman port pvc set <slot-port-vpi/vci> [<super>|<vid=<pvid>
[priority=<priority>]>] [llc|vc]
where
<slot-port-vpi/vci> = The slot, port, VPI and VCI numbers.
[<super>|<vid=<pvid>
[priority=<priority>]>
= The super channel inherits the port’s VID (PVID) and priority. You must
assign a VID and priority to normal channels.
[llc|vc] = The multiplexing mode.
The
pvc set
command allows the configuration of a PVC (permanent virtual circuit) for one or a range of
ADSL ports. Two examples are shown next.
ras> lcman port pvc set 3-1-0/34 super
ras> lcman port pvc set 3-1-0/35 vid=100 priority=1 llc
3.2.12 PVC Show Command
Syntax:
lcman port pvc show [slot-port-vpi/vci]
where
[slot-port-vpi/vci]
=
The slot, port, VPI and VCI numbers.
The
pvc show
command allows you to display the PVC parameters of one or a range of ADSL ports.