Zoomlion RT35, Руководство оператора

Страница: 45 / 171

RT35 Rough Terrain Crane 05 - 7
Use soft water, e. g. tap water, for coolant. Do not use hard water (river
water).
1 Do not add a large quantity of cold water too quickly. When it is
necessary to add cold water, put the water in slowly. Follow the below
instructions to add coolant:
 
Put together water, antifreeze and/or anti-rust fluid in the correct
ratio.
 
Loosen the cap to the coolant tank with a wet rag to release the
pressure in the tank. After you release the pressure, continue to
remove the cap. The fluid released is hot and pressurized and can
cause burns or blindness. Always keep your face away from the cap
on the coolant tank.


Add the water mix to the applicable coolant tank fill-line and then
install the cap.
Do not operate the engine continuously at high speeds without a load.
(
(
6
6
)
)
Put the crane in a lower gear before you move up a slope to decrease the
load on the engine and drive-line.
Note
Make sure that the RPM of the engine is around maximum when you move up a
slope.
Do not bypass gears when you move to a lower gear.
Slow the crane down before you change to a lower gear.
(
(
7
7
)
) Do the items that follow before you go down a long hill slope:

Make sure that the brake system can stop the crane before you go onto the
slope.

Put the transmission in the ”F1” position before you go down the slope.
(
(
8
8
)
) Know the below data while you steer the crane:

When you go into a corner, put the transmission in a lower gear and apply a
small quantity of pressure on the brakes.

The steering wheel has a mechanical limit. Do not continue to turn the wheel
when at the limit. Do not keep the wheel at the limit for long periods of time.
( ( 9 9 ) ) If the engine stops because the fuel tank is empty, air can go into the fuel system.
Caution
Caution
Caution