Zoomlion RT35, Руководство оператора

Страница: 133 / 171

RT35 Rough Terrain Crane 07 - 41
(10) Remove the pin (7) and retaining clip from jib section 2.
Figure 07 – 42 Pin (7) Removal
(11) Pull out the section 2, stop when it touches the limit stop. Align the holes and
install the pin (7) and the retaining clip.
Figure 07 – 43 Pin (7) Installation
(12) Reeve the wire-rope from the auxiliary winch through the end of the jib. Install the
auxiliary hook and the anti-two block switch.
E. Change the jib offset from 0
°
to 20
°
or 40
°
. Refer to Figure 07 – 44 and Figure 07 – 45.
(1) Fully retract the boom.
(2) Make sure that the outriggers are fully extended.
(3) Derrick the boom to 0° position.
(4) Reeve the hoist wire-rope through the jib sheave.
(5) Remove the pins and the retaining clips at point A from the pull bracket. Insert the
removed pins and retaining pins at point B for the 20° position or point C for the
40° position.
(6) Pay out the hoist rope and derrick the boom up slowly till pin at point B or point C
touches pin A.
Pin 7
Retaining clip
Pin 7