Zoomlion RT35, Руководство оператора

Страница: 103 / 171

RT35 Rough Terrain Crane 07 - 11
switch. The switch moves to the neutral position automatically.
3 Do this step until all 4 outrigger jacks are retracted.
(c) Push an outrigger switch (1 of 4) to the “BEAM” position.
1 Push the outrigger extend / retract master switch to the “RETRACT”
position at the same time.
2 After the outrigger retracts fully, release the master switch. The switch
moves to the neutral position automatically.
3 Do this step until all 4 outriggers are retracted.
(d) Install the outrigger retaining pins.
(3) Install and remove the outrigger floats.
(a) Installation
Before you extend the outriggers, remove the socket pin from the outrigger
floats and pull out the outrigger floats. When the hole aligns with the vertical
cylinder, install the socket pin.
(b) Removal
After you fully retract the outriggers, remove the socket pin and push in the
outrigger float until it in the correct position. Install the socket pins.


Before you move the outriggers, make sure that there is clearance to prevent
injury to personnel or damage to the crane and other objects.


Do not move the outriggers if you have a load off the ground.
 
You can adjust the speed (slow or fast) of the outriggers movement (extend or
retract) by the engine RPM (increase or decrease).
 
Make sure that you install the outrigger floats before you move the outriggers.


Make sure that you remove the retaining pins before you extend or retract the
outrigger beams. After the outrigger beams are in position, install the retaining
pins.
 
Before you extend or retract the outriggers, make sure that the floats are clear
from all objects.
 
Make sure that all the tires are off the ground (crane weight held up by the
outriggers) before you start to lift a load.
 
When the crane is on a level area, examine the bubble indicator. The bubble
shows in the middle of the indicator. If not, adjust the nuts below the indicator.
Caution