4-REAR WHELL COMPONENT
21
CHK
ADJ
NO.
PART NO.
PART NAME
QTY
CAUTION
1
1020242-263021 Rear auxiliary fender aluminum alloy bracket
1
2
1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
5
3
1224200-090000 Rear auxiliary fender retaining plate
1
4
1250105-137093 GB5789M6×16
（
color zinc
）
4
5
1274100-057095 Flanging bushing φ6.2×φ8.5×3.5
＋
φ14×1.5
5
6
1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
5
7
1250501-007093 GB93φ8(color zinc
）
3
8
1251100-101000 Non-standard bolt M6×12 (304 stainless steel)
6
9
1270300-039000 HJ125
－
6 rear license light bracket
1
10
1250303-010093 GB6177.1M6
（
color zinc
）
2
11
4021200-028000 KD150
－
U Rear bracket for rear auxiliary mud board
1
Fig.2 REAR WHELL
COMPONENT
U rear auxiliary mud board component 2
PROCEDURE:
●
Retaining plate
Remove the bolt
⑵
with 4# inner hexagon socket and the bolt
⑷
with a 10# sleeve, remove the flange bushing
⑸
the rubber pad
⑹
, and finally remove the retaining plate
⑶
.
●
Rear auxiliary mud board component
Hold the rear auxiliary mud board component,use 10#sleeve remove 3pcs bolts
⑷
,take off 3pcs spring washer
⑺
.Take off the rear auxiliary mud board component.
Fix bolts
⑻
with a 4# inner hexagon socket and remove nuts
⑽
with a 10# sleeve,at the license bracket
⑼
and
remove the license bracket
⑼
.
●
Iron bracket
Hold the iron bracket component, remove 4pcs bolts
⑵
fix the rear mud bosrd componet, and remove the
flange bushing
⑸
and rubber pad
⑹
.Take off the iron bracket component from the rear auxiliary mud board
component.
Using 4# inner hexagon socket remove 4pcs bolts
⑻
,remove the front iron bracket
⑿
and the rear iron bracket
⑾
.
CAUTION:
●
Do not pull the cable hard when removing the sub-mud switch.
●
When reassembling, first check if there is any pressure on the wire to prevent short circuit when tightening the
bolt.
12
4024200-035000 Front segment of ZT310
－
V rear auxiliary clay plate
and iron bracket
1
