Zodiac MS FILTER D470, Инструкция по установке и эксплуатации

Страница: 14 / 16

13
❺ Troubleshooting
• If a problem occurs, before you contact your retailer, please carry out these few simple checks
using the following tables.
• If the problem continues, contact your retailer.
• : Actions to be performed by a qualified technician only
Malfunction Possible causes Solutions
Low water flow rate.
• Pump pre-filter strainer and/or
filter clogged.
• Valves incorrectly set.
• Water leak.
• Clean the pump pre-filter strainer.
• Wash the filter media.
• Adjust the valves.
• Check that there are no leaks.
The pressure gauge
indicates a high pressure.
• Filter media clogged or too old.
• Valves incorrectly set.
• Wash the filter.
• Change the filter media.
• Adjust the valves.
Filter media in the pool.
• Incorrect filter media grain size.
• Too much filter media in the
filter.
• Manifold and/or manifold
strainers damaged.
• Check the filter media grain size, change if
necessary (see §4.1.3 Replacing the filter media ).
• Remove some filter media to obtain the correct
level (see §2.2.3 Filling the filter ).
• Replace the damaged manifold and/or manifold
strainers.
The pressure gauge
needle shakes violently.
• Air leak in the circuit.
• Suction valves half-closed.
• Check the connections and gaskets.
• Adjust the valves.
The water is cloudy.
• Filter media clogged.
• Water balance incorrect.
• Filtration time is insufficient.
• Wash the filter media to eliminate the foreign
bodies. If washing is insufficient, change the filter
media and check the condition of the manifold
and/or its strainers.
• Check and adjust the water balance.
• Wash the filter media and increase the filtration
time if this proves insufficient.
The filter must be
cleaned more frequently.
• Water balance incorrect.
• Filter media clogged.
• Organic proliferation in the
filter media.
• Check and adjust the water balance.
• Wash the filter. If washing is insufficient, change
the filter media.
• Clean the filter media using a special "filter
cleaner".
The multiway valve
sticks.
• The valve is clogged or contains
foreign bodies.
• Rinse the multiway valve. If this is
insufficient, dismantle it (respect precautions in
§2.2.2 Installing the multiway valve
), change it if
necessary.