Product Manual - ZMORPH FAB
76
Choose ‘
MANUAL 3-POINT
CALIBRATION’.
Wait until the extruder reaches
the calibration position, on
the left central part of the
worktable.
Clean the nozzle and table
from unnecessary material.
Take a small sheet of paper
and place it between the
nozzle and the worktable.
Set the nozzle at Z=0 for the
Point1.
Set the nozzle at Z=0 for the
Point1: move the axis to make
the nozzle barely touching the
bed.
Use the arrows to set
position. To verify the dis-
tance, you should be able
to place a sheet of paper
underneath
When done, tap ‘NEXT’.
Repeat for point number 2
and 3.
When finished tap ‘DONE’.
Manual 3-point calibration
process is finished!
RESTORE
FACTORY
DEFAULT
MANUAL
3-POINT
ADVANCED CALIBRATION
BACK
LESS
Set the nozzle at
Z=0
for
Point 1
:
move the axis to make the nozzle
barely touching the bed
P1
P2
P3
NEXT
BACK
MOVE Z
Calibration complete!
DONE
Set the nozzle at
Z=0
for
Point 1
:
move the axis to make the nozzle
barely touching the bed
P1
P2
P3
NEXT
BACK
MOVE Z
Set the nozzle at
Z=0
for
Point 2
:
move the axis to make the nozzle
barely touching the bed
P1
P2
P3
MOVE Z
NEXT
BACK
Set the nozzle at
Z=0
for
Point 1
:
move the axis to make the nozzle
barely touching the bed
P1
P2
P3
NEXT
BACK
MOVE Z
Set the nozzle at
Z=0
for
Point 3
:
move the axis to make the nozzle
barely touching the bed
P1
P2
P3
MOVE Z
BACK
DONE
NOTE
Move the paper between the nozzle and the worktable
surface. If the nozzle is too low, the paper won’t move. If the
nozzle is too high above the surface the paper sheet will be
loose. The best configuration is when the piece of paper rubs
against the nozzle but it’s not loose.
3D printing workflow
0,05mm
0,05mm
0,05mm
0,05mm
0,05mm
