Product Manual - ZMORPH FAB
129
CNC milling workflow
‘Eye protection required’ sign
▪
When working with the device with the spindle attached without covers (e.g. if material is larger than
the platform), provide the personnel and bystanders in the room with safety goggles,
▪
The electrical installation of the Zmorph Fab requires it to be connected to a grounded outlet,
▪
Place the device on a level and stable surface. The machine is equipped with a vibration-damping
base but when working on uneven or sloping surface, vibrations can cause the device to move,
▪
The room where the Zmorph Fab device with the CNC Milling Toolhead is located must be well ven-
tilated as vapours may escape from the device during operation,
▪
If you install a Zmorph Fab device with the CNC Milling Toolhead in a room where smoke detectors
are installed, make sure they do not cause false alarms.
Health and safety instructions for handling CNC Milling Toolhead.
General information.
▪
Use the Zmorph Fab device with the CNC Milling Toolhead in a separate room which cannot be
accessed by children or unauthorized persons,
▪
Do not put your hands in the workspace after turning on the spindle. The spindle rotates at high
speed and has rotating blades that can cause serious injuries,
▪ Use of the machine by unqualified personnel can lead to injury and/or damage to the machine,
▪
If you notice any malfunctions of the machine, stop it immediately by pressing the reset button (red
ring button on the right on the front panel of the machine) and contact Zmorph Technical Support,
▪
Do not use a malfunctioning machine under the risk of voiding the warranty,
▪ Make sure that the material to be machined is firmly attached to the work platform and cannot move
in any direction. Failure to follow the instructions may result in injury and/or damage to the machine,
▪
When using a Zmorph Fab machine with the CNC Milling Toolhead without covers, both operators
and bystanders must always wear safety goggles; failure to do so may result in eye damage.
