3 System Menus
34
Config
:
indicates that the option is selected. If
is marked for
All
, all four alarm outputs are
configured. If
is marked for
1
,
2
,
3
, or
4
, alarm output 1, 2, 3, or 4 is configured.
Always
:
indicates that the option is selected. If
is marked for
All
, all four alarm outputs are
always enabled. If
is marked for
1
,
2
,
3
, or
4
, alarm output 1, 2, 3, or 4 is always enabled.
Close
: This option is used to disable alarm outputs.
Status
: This option is used to display the alarm output status of the current device.
3.5.6
Abnormity
You can set the event type and associated actions on the
Abnormity
screen. Select
Enable
. When an
abnormity occurs, the system automatically generates alarms, displays messages on the screen, and
sends emails. To access the
Abnormity
screen, choose
Main Menu
>
Alarm
>
Abnormity
.
Event Type
: Abnormity event types include
No hard disk
,
Disk Error
,
Disk No Space
,
Network
Disconnection
, and
IP conflicted
.
No hard disk
: No hard disk is installed on the NVR, or the hardware system is faulty and fails to detect
hard disks.
Disk Error
: Hard disks are faulty, or the system fails to detect hard disks.
Disk No Space
: No storage space is available on the hard disks. (When
Event Type
is set to
Disk No
Space
, the system prompts you to set the lower limit, that is, the percentage of the free disk space.)
Network Disconnection
: The NVR is disconnected from the network, or network connection errors
occur.
IP Conflicted
: The NVR has a fixed IP address, which is the same as that of another device on the
network.
Enable
: It is used to enable a function.
indicates that the function is enabled.
Alarm Out
: Start the device connected to the alarm output terminal when an abnormity occurs. Select
one or more alarm output channels.
Show Message
:
indicates that this function is enabled. Messages are automatically displayed on
the screen when an alarm signal is generated.
Send Email
:
indicates that this function is enabled. An email is sent to the specified address when
an alarm signal is generated.
Alarm duration
: set the alarm output delay. It ranges from 10 seconds to 300 seconds.
