INSTALLATION AND OPERATING INSTRUCTIONS:
O-ring assembly gripper, pneumatic, GS series
Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau, Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
16
EN / 2020-11-30
DDOC00228 / g
10 Accessories/scope of delivery
INFORMATION
If any accessories not sold or authorized by Zimmer GmbH are used, the function of the product cannot be
guaranteed. Zimmer GmbH accessories are specifically tailored to the individual products.
Optional accessories and those included in the scope of delivery can be found at
www.zimmer-group.com
.
11 Transportation/storage/preservation
►
The product must be transported and stored only in the original packaging.
►
If the product has already been installed on the superordinate machine unit, care must be taken during transport to
ensure that no unintentional movements can occur. Before commissioning and after transporting the product, check all
power and communication connections as well as all mechanical connections.
►
If the product is stored for an extended period, the following points are to be observed:
• Keep the storage location as dust-free and dry as possible.
•
Avoid temperature fluctuations/observe and adhere to the temperature range.
• Avoid wind/drafts/water condensation formation.
• Pack the product and do not expose it to direct sunlight during storage.
►
Clean all components. There must be no dirt left on the components.
►
Visually inspect all of the components.
►
Remove all foreign substances.
►
Properly remove potential corrosion spots.
►
Seal electrical connections using suitable covers.
12 Decommissioning/disposal
INFORMATION
When the product reaches the end of its service life, it can be completely disassembled and disposed of.
Completely disconnect the product from the power supply.
The product can be disassembled and properly disposed of according to material groups.
When disposing of it, observe the locally applicable environmental regulations and codes and regulations for
disposal.
