INSTALLATION AND OPERATING INSTRUCTIONS:
O-ring assembly gripper, pneumatic, GS series
13
Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau, Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
EN / 2020-11-30
DDOC00228 / g
3
Sensors
Detecting the end position enables a shorter cycle time and
continuous control.
4
Inductive proximity switches
►
Install the mounting block
cn
on the mounting surface
co
below the spread jaws.
►
Insert the proximity switch
cp
into the mounting block
cn
.
►
Then, flare the spread jaws and adjust the proximity
switch.
►
Clamp the proximity switch
cp
by tightening the screws on
the mounting block
cn
.
cn
cp
cn
cp
co
3
4
5
Magnetic field sensor
►
Insert four magnetic field sensors
cq
into the
corresponding grooves
cr
.
►
Bleed the product completely and adjust one magnetic
field sensor
cq
to the lower position of each of the two
pistons.
Ö
LED lights up.
►
Mark this position on the housing.
►
Insert the magnetic field sensor
cq
far enough that the
LED goes out.
Ö
LED out.
►
Mark this position on the housing.
►
Then, push the magnetic field sensors
cq
back to the
initial position until the LED lights up.
Ö
The optimum magnetic field sensor position
cq
is
between the two marked positions.
►
Extend the spread jaws and the ejector.
Ö
Repeat the adjustment process at the other magnetic field
sensors
cq
as described.
5
