ZNEO
®
Series of Microcontrollers Development Kit
QS005703-0908
Page 3 of 18
Figure 1. ZNEO Development Board
Jumper Settings
The jumper settings to set up the ZNEO development board is provided below:
1. For initial setup, ensure that jumper J2, DIS RS232, is OUT (shunt not installed) and
jumper J3, DIS IRDA, is IN (shunt installed). For detailed jumper descriptions, refer
to the
Z16F2800100ZCOG ZNEO
®
Series Development Kit User Manual (UM0202)
.
2. The development kit is preprogrammed with code for demonstration and to verify that
the board is working properly.
To run the preprogrammed Demo, ensure that jumpers and switches are set as follows:
–
J1 OUT
–
J2 OUT
DBG Connector
Pin 1 (indicated
by square)
