ZNEO
®
Series of Microcontrollers Development Kit
QS005703-0908
Page 9 of 18
–
Switch S3 is used to control the sequence in which LEDs D2, D3, and D4 flash,
when running the Demo program.
2. Connect and apply power to the development board as described in
on Page 2 through Page 8.
Do not apply power to the development board unless the USB Smart
Cable is connected to the host PC and to the development board’s DBG
Port P3.
3. Run the ZDS II software. By default, the ZDS II is located in the
Start
menu under
:
Programs
→
ZiLOG ZDS
II ZNEO <version_number>
→
ZDS
II ZNEO
<version_number>
4. Select
Open Project
from the
File
menu. The
Open Project
dialog box appears.
The sample used in the following steps is in the ‘C’ programming language.
An assembler version of the Quick Start sample is located in the
samples\Assembly
folder.
5. Browse to the
Samples
folder for the
Z16F2800100ZCOG.zdsproj
file, located by
default in below path:
c:\Program Files\ZiLOG\ZDSII_ZNEO_<version_number>\samples\
QuickStart
6. Select the
Z16F2800100ZCOG.zdsproj
file and click
Open
. The initial ZDS II
program screen opens (see
To view the project source files, double-click the
Project Files
folder on left side of
the IDE interface. Double-click an individual file to open that file in the ZDS II file
editor.
The following figures are for reference only. The results may vary slightly
due to configuration differences or later software revisions.
Caution:
Note:
Note:
