ZNEO
®
Series of Microcontrollers Development Kit
QS005703-0908
Page 7 of 18
Windows 98SE
Follow the steps below to install the USB Smart Cable for Windows 98SE:
1. Connect the USB Smart Cable to the host PC for the first time.
The
Found New Hardware
wizard should activate automatically.
2. In the Wizard, click
Next
.
3. Select
Search for the best driver for your device (Recommended);
then click
Next
.
4. Select
Specify a location
; then browse to one of the following driver directory:
<Zilog Developer Studio II Installation Directory>\
device drivers\USB
<Zilog Developer Studio II Installation CD>\Device Drivers\USB
5. Click
Next
, and then click
Next
again after the appropriate driver is found.
6. Click
Finish
to complete the installation.
Connecting the USB Smart Cable to the Target Board
Follow the steps below to connect USB Smart Cable to the development board:
1. Attach one end of the six-conductor ribbon cable (included) to the USB Smart Cable
2. Attach the free end of the ribbon cable to the DBG connector on the target board.
Ensure that pin 1 on the ribbon cable (indicated by the dark stripe) is aligned with
pin 1 on the target connector (see
on page 3 for location of pin 1 on the
ZNEO development board).
Figure 2. Connecting the Six-Conductor Ribbon Cable to the USB Smart
Cable
