ZIGOR SOLAR HIT3C, Руководство по эксплуатации

Страница: 61 / 116

Operating Manual ZIGOR SOLAR HIT3C
© ZIGOR 1
1 PRECAUTIONS
1.1 General precautions
For your own safety and that of the unit, you must read and understand the instructions
contained in this document before starting work.
Keep these instructions in a place accessible to all the personnel who work with the unit so that
these may be consulted.
Only expert and duly authorised personnel may operate our units.
Danger warnings . When handling or gaining access to the interior of the equipment, please
remember that some parts may be live. Pay special attention to soldering points, printed
circuits, connecting terminals, relay contacts, etc. Before opening the equipment, disconnect
the voltage of all poles (both alternating and direct) and wait at least 5 minutes for the internal
condensers to discharge.
Arbitrary modifications are forbidden . The unit must not be subjected to any modification regarding its
construction or safety without ZIGOR’s express consent. Any modification shall free ZIGOR of any
responsibility for any damage caused as a result of the modification. In particular, all repair work,
soldering of printed circuit boards and replacing of components, modules and printed circuit boards,
without the express authorisation of ZIGOR, is forbidden. Should spare parts be used, only ZIGOR
original parts shall be utilised.
ZIGOR accepts no responsibility for any inadequate, negligent or incorrect installation of the equipment.
Use the unit for the purpose for which it was designed. The system supplied must be used only for the
purpose for which it was designed. Any other use is strictly forbidden. ZIGOR cannot accept
responsibility for any damage that might result from its use for any other purpose. In such cases, the
user shall assume exclusive responsibility for any risk. The use for which the unit was designed is
defined in the documentation. The system shall be exposed only to admissible environmental
conditions. These are specified in the technical details provided for the equipment.
Please follow the indications set out below to operate under conditions of complete safety:

The System must be checked once the installation has been completed by a q ualified technician
and before being put into operation. Should these indications not be adhered to, the warranty shall
be considered null and void.

These units do not contain parts usable for other purposes by the user.

Do not power up the device before a technician has checked it.

The unit does not contain any user repairable or replaceable elements. In the case of any
malfunction or problems operating the unit, please contact ZIGOR.

Do not place the ZIGOR SOLAR HIT3C near power magnets as this might cause a malfunction.

Do not block or cover the ventilation grills in the housing.

Should you have any problems with the contents of this manual, you must ask ZIGOR for
assistance.

The ZIGOR SOLAR HIT3C is designed in accordance with current Spanish legislation. Check
these regulations against those corresponding to the country in which the unit is to be installed
and against the most restrictive regulations of the electricity supplier.

Once installed, the system does not need to be opened. All user controls are accessible from the
exterior.

Work inside the cabinet should be undertaken only by qualified personnel who are familiar with the
safety measures to be applied and the specific technical characteristics of the unit.

When the cabinet is opened, the system stops.

The general switch disconnects the input and output power contactors unconditionally.