STW164IP
12660-0710-00
Page
12 / 30
www.ziehl.de
7.2.1 Addition time
The filters are cleaned after the addition time
[cleaning / addition time]
has elapsed
Calculation of the addition time:
>
Extraction runtime [min.] x volume flow [%]
For example, if the extraction system runs for 120 minutes with a volume flow of 50%,
>
120 minutes x 50% = 60 minutes
is added to the addition time.
The addition time is stored in the device with zero voltage protection.
7.2.2 Cleaning procedure
➢
The extraction is off
➢
After the rundown time (starts when extraction is off)
➢
Starts cleaning (relay K2 on)
➢
The following process is repeated x times (x = vibration intervals)
•
Cleaning active (relay K2 on)
•
Cleaning break (relay K2 off)
➢
Cleaning is then active for the continuous vibration time
➢
End of cleaning (relay K2 off)
[Cleaning / Rundown time]
[Cleaning / Vibration Intervals]
[Cleaning / Vibration time]
[Cleaning / Continuous vibration
time]
If cleaning is interrupted (a machine switches on) and at least 50% of the continuous shaking time has not
yet elapsed, cleaning is restarted at the next opportunity.
7.3 Discharge
Two different discharge modes are available.
7.3.1 Starts with extraction
Discharge - Starts with extraction
Starts:
when at least one slider is open
Ends:
- when cleaning is complete and the
subsequent overrun time has elapsed, or - when the
extraction has ended and the subsequent overrun time
has elapsed
[Discharge / Starts with]
[Discharge / Overrun]
7.3.2 Starts with cleaning
Discharge - Starts with cleaning
[Discharge / Starts with]
Starts:
when the addition time has elapsed (= 0)
Ends:
- when cleaning is complete and the subsequent overrun
time has elapsed
[Discharge / Overrun]
7.4 Input Y1 (I0&I31)
Function - Switch
[Machine / Input Y1]
all sliders (flaps) open when input Y1 closed
Function - 00:10.59:59 [mm:ss]
[Machine / Input Y1]
all sliders (flaps) open for the specified time (input Y1 = swipe signal/button)
•
The volume flow takes into account the open sliders (total volume flow of all extraction channels)
•
The function "
Extraction/further opening = no
" is not active (open all)
•
When extraction off: Extraction starts without delay
