ZIEHL-ABEGG FXET4AMQ, Руководство по эксплуатации

Страница: 52 / 87

9.10.2.4 Limit ON / OFF, Function
|
3D
|
The value for “ Limit ” adjusted in the Controller Setup, is activated over a digital input.
Contact e.g. at ditgital input “ Digital In 1 ” (depending on device type at terminals “ D1 ” - “ D1 ” or “ D1 ” -
“ 24 V ” ).
For “ D1 ” Inverting “ OFF ” , limitation active at closed contact.
Controller
24V
D1 D1
1 0
n = 0- 80 % 1
0
- - - - -
n = 0- 100 %
10.05.2007
v_3d_limit.vsd
1
1 Setting “ Limit ” (depending on device type in: %, Hz, rpm)
9.10.2.5 Switch over Input signal “ E1 ” / “ E2 ” , Function
|
4D
|
Switch over between Input signal 1 (Analog In 1 terminal “ E1 ” ) and input signal 2 (Analog In 2 terminal
“ E2 ” ).
Contact e.g. at ditgital input
“
Digital In 1
”
(depending on device type at terminals
“
D1
”
-
“
D1
”
or
“
D1
”
-
“ 24 V ” ).
24V
D1 D1
1 0
n = 0- 100 %
0
1
Si 1
Si 2
E1
GND
E2
GND
Si 1
Si 2
26.05.2010
v_4d_umschaltung_e1_e2.vsd
Controller
Si 1 Signal 1
Si 2 Signal 2
For mode speed controller ( 1.01 ) Base setup for “ E2 Analog In ” :
|
1E
|
necessary.
9.10.2.6 Set 1/2 or Setpoint 1/2, Function
|
5D
|
Switch over between “ Set Intern1 ” and “ Set Intern2 ” (for speed controller 1.01 )
Contact e.g. at ditgital input “ Digital In 1 ” (depending on device type at terminals “ D1 ” - “ D1 ” or “ D1 ” -
“ 24 V ” ).
Controller
24V
D1 D1
1 0
n = 40 % 1
n = 80 %
0
- - - - -
- - - - -
11.05.2007
v_5d_vorgabe_intern_1_2.vsd
2
1
1 Setting “ Set Intern1 ” (depending on device type in: %, Hz, rpm)
2 Setting “ Set Intern2 ” (depending on device type in: %, Hz, rpm)
• “ D1 Inverting ”
=
“ OFF ”
:
“ Set Intern1 ”
at
opened contact /
“
Set Intern2
”
at closed
contact.
• “ D1 Inverting ”
=
“ ON ”
:
“ Set Intern1 ”
at
closed contact /
“ Set Intern2 ”
at opened
contact.
Operating Instructions Fcontrol – model series FXET4/6/10AMQ Programming
L-BAL-E079-GB 1706 Index 008 Part.-No.
52/87