Ziegler PKT 960, Инструкция по эксплуатации и список запасных частей, Страница: 30 / 54

- 30 -
b) Mounting of the Tensioning Strips
Both tensioning strip ends are passed through the according slot hole (at the beginning and the
end) of the tensioning strip (strip with slanted perforation). After approximately 30 mm, these
ends are bent backwards and placed beneath the tensioning strip (see Page - 29 -,Diagram
2 ).
The bent around ends are consequently situated between the tensioning strip and the worm
pipe.
Subsequently place the tensioning strip over the nozzle retaining plates and around the worm
pipe. Place the perforated strip beneath the latch of the turnbuckle and close the locking
device. Having performed this,
tightly fasten the tensioning strip in order to ensure that
the sealing rubber with the nozzle retaining plate adjusts well to the radius of the worm
pipe to prevent leakage
.
Tensioning Strip Lengths for:
Worm Pipe Diameter 102 mm
280 mm
„
127 mm 360 mm
„
152 mm 440 mm
„
200 mm 590 mm
„
220 mm 650 mm
„
250 mm 745 mm
20
34
0
34
0
34
0
Trichter
A
A
40
80
Ansicht A-A
Maße in mm
Klemmrohr - Muffe
Schneckenrohr
* mit Maß am Düsenstock überprüfen. * mit Maß am Düsenstock überprüfen.
*
*
*
40
Diagram 3
Worm Pipe
Perspective A-A
Clamping Tube Collar
Funnel
Verify with gauge at nozzle holder
Measurements stated in mm