Zepro ZHDN 2500-150, Руководство по установке, Страница: 44 / 58

ZHDN 2500-150
44
Connection unit
www.zepro.com
9.5 Sensor
Name Position
(standard)
Function Description
Di1 Lift arm Angle sensor For autotilt, safety function.
Di2 Platform Angle sensor For autotilt, platform angle.
Di3 Platform Non-actuated Di3 disables Tilt up with the secondary control
device so that the operator must use the two-hand button - 2H
along with the primary control device in order to continue to
maintain the tilt up function.
Di4 Tilt cylinder Open platform
alarm
Pressure sensor for falling pressure connected to +side of tilt
cylinder. In the actuated state, returns the connection signal
(+) to Di4 and resulting in output signal (-) at Pa-. Also phase
(+) signal out at Pa+.
Di5 Lift cylinder Pressure sen-
sor fitted to lift
cylinder
Pressure sensor for increased pressure connected to +side
of lift cylinder. In the actuated state, returns the connection
signal (+) to Di5 and resulting in output signal (-) at Pa-. Also
phase (+) signal out at Pa+.
Di6 Control card Jumper Jumper to deactivate autotilt functions.
Cs Cabin Activation No signal in at Cs results in blocked control device terminals.
Signal to Cs usually comes from the cabin switch. In
individual cases where the cabin switch is not used, the (+)
signal comes in to Cs jumpered from (+) on nearby terminal.
2H1 Control devices Two-hand but-
ton
Activated in connection with opening and closing of vehicle
body. Used for Quick opening.
Angle sensor Platform Quick opening Activated for tilt down to about 15º. Operates its own valve.