Zepro ZHDN 2500-150, Руководство по установке

Страница: 28 / 58

ZHDN 2500-150
28
Installation
www.zepro.com
2
3
5
4
End stop
Adjusting collar
Lock screw
The tilt angle must be set at 90º to the
vehicle body before the downward tilt
angle is adjusted (see previous page).
NOTE.
To ensure that the lift is safe and CE
compliant, the downward tilt angle
must be adjusted to max. 10º.
m
WARNING!
1. Raise the lift to the vehicle floor. See
illustration.
2. Loosen the lock screw of the end stop
(2). Screw the end stop all the way
back towards the platform (3). See
illustration.
3. Tilt the platform down to max. 10
degrees below the horizontal. See
illustration.
4. Adjust the end stop all the way to the
top of the cylinder (4).
5. Tighten the lock screw in the end stop
(5). See illustration.
The tightening torque for lock screws is
between 3-5 Nm
Test all functions.
The tilt angle of both cylinders must
be adjusted to be the same, otherwise
they may be damaged.
m
WARNING!
6.14.2 Adjusting the downward tilt angle.
Bolt
Washer
Image 43. The tilt angle must be ad-
justed to max.10º down
Image 44. End stop with lock screw
Image 45. Tilt cylinder